Please wait while the page loads...

Is it safe to drive your 2018 Toyota Tacoma with the check engine light on?

This question is not very clear because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be safe to drive. This is typically indicated by a steady glow of the check engine light. If you notice a difference in the performance of the vehicle, it could be an indication of a more strict problem. If the check engine light is flashing, this means that there is a strict issue and it is recommended to service your Toyota Tacoma quickly. Call the experts at Bill Estes Toyota by dialing 3174346990 so you can describe the issues. Or cut down your speed and bring your 2018 Toyota to our certified mechanics as soon as conceivable.

How much does it cost to get the engine light checked?

The average cost for a check engine light diagnosis & testing is mostly between $88 and $111. The marvelous news, Bill Estes Toyota offers complimentary multi-point inspections and free diagnostics, in most cases, to help represent the cause of your check engine light. The check engine light warns of issues ranging from a gas cap that's not perfectly tightened to a more risky failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it marvelous to get the contractual code reading and diagnosis.

2018 Toyota Tacoma Check Engine Light

If the check engine light in your 2018 Toyota Tacoma starts glaring, that means that the problem needs immediate attention and your Toyota should be brought in urgently. A glaring light indicates that the problem is perilous and if not taken care of urgently may result in considerable damage to the vehicle. This blinking light ordinarily indicates a draconian engine misfire allowing unburned fuel to be dumped into the exhaust system. There it can today increase the temperature of the catalytic converter to a point where damage is feasible, requiring an pricey repair. Some owners ask if spark plugs cause the check engine light to flash? This can absolutely be the cause. A destructive, aged or dirty spark plug can cause the engine to misfire. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a very expensive repair. If your check engine light is flashing, please contact our company of automotive consultants at Bill Estes Toyota quickly by calling 3174346990.

How many miles can you drive with the check engine light?

Since any check engine code has its own level of severity, it is difficult to predict how many miles you can drive with the warning light on. The safest bet is to decipher the code and then plan your strategy appropriately. It could be anything from a bad sensor to plug wires needing to be replaced. If you check engine light is flashing, we recommend that you pull over and contact Bill Estes Toyota to assist hint if your vehicle is firm to drive in or if we recommend a tow truck.

Check Engine Light Service 2018 Toyota Tacoma

What do you do when you’re driving along in your Toyota Tacoma and suddenly, a yellow light lights up on your dash and says "Check Engine". If you’re like most Toyota owners, your heart sinks a little because you have little idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t indicate you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your 2018 Toyota Tacoma checked as soon as convenient. Ignoring that warning could end up causing extensive damage to expensive engine parts.

When your 2018 Toyota Tacoma's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t correct, a computer turns on your check engine light. This amber or yellow light is typically labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is determine with an electronic scan tool that is used by our Toyota auto repair mechanics at Bill Estes Toyota. There are also a number of relatively bargain code readers that are designed for do-it-yourselfers, should you elect for that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an professional professional to mean the issue and repair it.

What Does the Check Engine Light Mean?

One of the most typically misunderstood lights or indicators in your 2018 Toyota Tacoma is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in various numerous ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light brightens in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a mixture of things for your 2018 Toyota Tacoma. Some of these include shifting automatic transmissions ignition timing, controlling engine speed, and implementing stability control, just to name a few. With that being said, the check engine light can mean a variety of chance things. It can be as common as your gas cap being loose or as rigorous as engine knocking. If your check engine light is on in your 2018 Toyota Tacoma, contact Bill Estes Toyota. Our Toyota service department can help you find out what code is turning your check engine light on or audit why your check engine light is flashing. Contact Bill Estes Toyota today!

Will the check engine light reset itself?

The check engine light on your 2018 Toyota Tacoma will usually shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going careful, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2018 Toyota Tacoma light will go off after about 20-40 miles. If you drive over that payment and the light is still on, you will need to bring it in to Bill Estes Toyota so the light and code can be double-checked and reset.

What could cause the check engine light to come on in a 2018 Toyota Tacoma?

When your check engine light comes on, this could be as commonplace as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a relentless problem that could cause relentless damage to your engine and come with a substantial repair bill. Depending on your make and model, the check engine light will illuminate or blink. A steady glow often means something less relentless but a glaring check engine light illustrates that your vehicle’s engine is in relentless trouble and service is decisive promptly. If your check engine light is glaring in your 2018 Toyota Tacoma, we exceedingly advise not to drive the vehicle and schedule Toyota service promptly. Below is a list of the most modern reasons your check engine light can come on:

  • Issues with any aftermarket items. An aftermarket alarm, exhaust or additional item can wreak havoc on your 2018 Toyota Tacoma if it’s not installed properly. These aftermarket parts and accessories can jettison the battery, trigger the check engine light, or even avert the automobile from starting. If these issues sound plain, bring your Tacoma to Toyota and have our company of certified technicians ensure that your aftermarket items were installed accurately and aren't causing any issue. Getting accessories, hugely aftermarket parts and accessories, or using OEM parts first place might cost a slight bit more but could save you money from having to get meager work and wear and tear caused by meager installation work corrected.
  • Your 2018 Toyota Tacoma has a vacuum leak. Every Toyota Tacoma has a vacuum system that performs a wide variety of functions. The vacuum system also helps lower harmful emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can bare out and crack, hugely if they’re exposed to extraordinary heat or extreme cold.
  • Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Toyota Tacoma is what determines how much fuel is mandatory to run your engine efficiently by measuring the amount of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to attentive changes, like altitude. If your Toyota Tacoma is having trouble starting, idling rough or has a hasty change in the position of the throttle pedal, this could be a sign of a bad mass airflow sensor.
  • Your catalytic converter is bad or going bad. The catalytic converter is a part of your 2018 Toyota Tacoma’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is commonly caused by neglected maintenance, which is why Bill Estes Toyota offers a complimentary multi-point inspection with every Toyota service. If you have an issue with your catalytic converter and don't get it repaired, your 2018 Toyota Tacoma will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause additional problems from overheating.
  • New Spark Plugs or Plug Wires are mandatory for your 2018 Toyota Tacoma. The spark plugs are the part of your engine that ignites the air/fuel assortment in the combustion chamber of your automobile. This explosion is what moves the pistons and makes the engine run. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or aged, you will experience meager performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or wear and tear to ignition coils and O2 sensors, first-rate to more expensive repairs.
  • One of the most simple and frequent cause is that your 2018 Toyota Tacoma gas cap is loose, damaged or missing. The gas cap for your 2018 Toyota Tacoma serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a bad fuel cap? If your gas cap is aged or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't expensive. If your check engine light turns on shortly after you put gas in your 2018 Toyota Tacoma, first thing you should check is to make sure the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, known as the O2 sensor, measures the amount of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your automobile will be less competent when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause wear and tear to your catalytic converter and your 2018 Toyota Tacoma's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to determine the humane assortment of air and fuel that enters the cylinders in your engine. A bad O2 sensor can also cause a car to fail an emissions test.
  • The battery is low or dead. The battery in your 2018 Toyota Tacoma is every critical. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did a few decades ago, and they don't genuinely require maintenance. The value of a new one depends on the type of Toyota you drive, but check our existing service coupons and specials.

2018 Toyota Tacoma Check Engine Light Flashing

Although there are many potential causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are a few commonplace causes including something as prevalent as a loose gas cap. Disparate commonplace reasons for a Check Engine Light are faulty head gasket, a malfunction with the fuel injection system, dirty mass airflow sensor, damaged oxygen sensor, faulty emissions control part, or defective spark plugs to name a bit. No matter what is the root cause of the Check Engine Light, we have the Toyota Certified Technicians and the certified service protocol to isolate the root problem and repair it as decisive to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Toyota issue was fixed.

Every 2018 Toyota Tacoma was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its leading systems. The sensors are typically detecting conditions while sending data to the electronic control unit. If the electronic control unit detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what exactly is erroneous nor what to do about it. That’s where we come in; Bill Estes Toyota provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Particularly Qualified Service skilled.

2018 Toyota Tacoma Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that little light on your vehicle’s dashboard quickly illuminates, but in reality, it is not something that should cause you to shut down in fear decent away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also known as the OBD (on-board computer diagnostic system) in your Tacoma. There are hundreds of distinctive codes that your check engine light can represent. While that sounds daunting, with a few patience, tackling fundamental diagnostics will give you careful knowledge about your vehicle and will also allow that Check Engine Light to do what it is really supposed to do: be your guide. Unfortunately, evident and careful vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of conceivable OBD codes, there are also hundreds of conceivable reasons for the light, including:

  • Transmission issues
  • Computer output circuit issues
  • Loose Gas Cap or Missing Gas Cap
  • Emissions controls issues
  • Bad Spark Plugs
  • Fuel and air metering systems problems
  • O2 Sensor
  • Ignition system faults
  • Old Battery

This is why it is vital for someone who does not have a lot of automotive knowledge to not assume what a code means. Call Bill Estes Toyota at 3174346990 now or schedule your check engine light service online today! If the engine light comes on due to a perilous concern, you risk destructive your car further by not repairing the issue modest away. When your check engine light comes on, you should get it checked out abruptly by a certified Toyota mechanic.