Please wait while the page loads...

How many miles can you drive with the check engine light?

If you check engine light is flashing, we endorse that you pull over and contact Bill Estes Toyota to help pick if your vehicle is safe to commute in or if we endorse a tow truck. Since every check engine code has its own level of severity, it is difficult to predict how copious miles you can commute with the warning light on. The safest bet is to decipher the code and then plan your strategy accordingly. It could be anything from a bad sensor to plug wires needing to be replaced.

2018 Toyota Corolla Check Engine Light

If the check engine light in your 2018 Toyota Corolla starts flashing, that means that the problem needs sudden attention and your Toyota should be brought in today. A flashing light illustrates that the problem is active and if not taken care of today may result in major damage to the vehicle. This blinking light frequently implies a relentless engine misfire allowing unburned fuel to be dumped into the exhaust system. There it can hastily raise the temperature of the catalytic converter to a point where damage is cooperative, requiring an expensive repair. Some owners ask if spark plugs cause the check engine light to flash? This can exactly be the cause. A bad, classical or dirty spark plug can cause the engine to misfire. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a very expensive repair. If your check engine light is flashing, please contact our unit of automotive experts at Bill Estes Toyota suddenly by calling 3174346990.

What could cause the check engine light to come on in a 2018 Toyota Corolla?

When your check engine light comes on, this could be as uncomplicated as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a critical problem that could cause critical damage to your engine and come with a enormous repair bill. Depending on your make and model, the check engine light will illuminate or blink. A steady glow frequently means something fewer critical but a twinkling check engine light indicates that your vehicle’s engine is in critical trouble and service is fundamental quickly. If your check engine light is twinkling in your 2018 Toyota Corolla, we greatly suggest not to drive the automobile and schedule Toyota service today. Below is a list of the most suitable reasons your check engine light can come on:

  • New Spark Plugs or Plug Wires are needed for your 2018 Toyota Corolla. The spark plugs are the part of your engine that ignites the air/fuel variety in the combustion chamber of your vehicle. This explosion is what moves the pistons and makes the engine run. The spark plug wires transport the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are detrimental or long-established, you will experience poor performance and reduced power. In a few extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, first-rate to more expensive repairs.
  • Your catalytic converter is detrimental or going detrimental. The catalytic converter is a part of your 2018 Toyota Corolla’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is usually caused by neglected maintenance, which is why Bill Estes Toyota offers a complimentary multi-point inspection with every Toyota service. If you have an issue with your catalytic converter and don't get it repaired, your 2018 Toyota Corolla will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your vehicle may run at a higher temperature, too, which can cause discrete problems from overheating.
  • Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Toyota Corolla is what determines how much fuel is needed to run your engine efficiently by measuring the amount of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to vital changes, like altitude. If your Toyota Corolla is having trouble starting, idling rough or has a immediate change in the position of the throttle pedal, this could be a sign of a detrimental mass airflow sensor.
  • Issues with any aftermarket items. An aftermarket alarm, exhaust or discrete item can wreak havoc on your 2018 Toyota Corolla if it’s not installed appropriately. These aftermarket elements and accessories can drain the battery, trigger the check engine light, or even prevent the vehicle from starting. If these issues sound conscious, bring your Corolla to Toyota and have our team of certified mechanics ensure that your aftermarket items were installed appropriately and aren't causing any issue. Getting accessories, exceptionally aftermarket parts and accessories, or using OEM elements first place might cost a little bit more but could save you money from having to get poor work and damage caused by poor installation work corrected.
  • The battery is meager or dead. The battery in your 2018 Toyota Corolla is every vital. Without a vehicle battery, your vehicle won’t start, light up the road ahead, play the radio or charge your phone. Today’s vehicle batteries last much longer than they did a few decades ago, and they don't absolutely require maintenance. The price of a new one depends on the type of Toyota you drive, but check our current service coupons and specials.
  • Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, known as the O2 sensor, measures the amount of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your vehicle will be less functional when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your 2018 Toyota Corolla's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to choose the good variety of air and fuel that enters the cylinders in your engine. A detrimental O2 sensor can also cause a vehicle to fail an emissions test.
  • One of the most daily and innumerable cause is that your 2018 Toyota Corolla gas cap is loose, damaged or missing. The gas cap for your 2018 Toyota Corolla serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a detrimental fuel cap? If your gas cap is long-established or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't expensive. If your check engine light turns on suddenly after you put gas in your 2018 Toyota Corolla, first thing you should check is to make hopeful the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • Your 2018 Toyota Corolla has a vacuum leak. Every Toyota Corolla has a vacuum system that performs a wide variety of functions. The vacuum system also helps cut down harmful emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dehydrated out and crack, exceptionally if they’re exposed to imposing heat or extreme cold.

2018 Toyota Corolla Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that little light on your vehicle’s dashboard suddenly brightens, but in reality, it is not something that should cause you to shut down in fear prudent away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also acknowledged as the OBD (on-board computer diagnostic system) in your Corolla. There are hundreds of discrete codes that your check engine light can represent. While that sounds daunting, with a little patience, tackling mandatory diagnostics will give you available knowledge about your vehicle and will also allow that Check Engine Light to do what it is really supposed to do: be your guide. Unfortunately, accessible and helpful vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of feasible OBD codes, there are also hundreds of feasible reasons for the light, including:

  • O2 Sensor
  • Old Battery
  • Bad Spark Plugs
  • Emissions controls issues
  • Ignition system faults
  • Transmission issues
  • Computer output circuit issues
  • Loose Gas Cap or Missing Gas Cap
  • Fuel and air metering systems problems

This is why it is needed for someone who does not have assorted of automotive knowledge to not assume what a code means. When your check engine light comes on, you should get it checked out quickly by a certified Toyota mechanic. Call Bill Estes Toyota at 3174346990 today or schedule your check engine light service online today! If the engine light comes on due to a hazardous concern, you risk detrimental your car extra by not repairing the issue honest away.

2018 Toyota Corolla Check Engine Light Flashing

Although there are countless capacity causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are many simple causes including something as simple as a loose gas cap. Assorted simple reasons for a Check Engine Light are a malfunction with the fuel injection system, damaged oxygen sensor, dirty mass airflow sensor, faulty head gasket, faulty emissions control part, or defective spark plugs to name a few. No matter what is the root cause of the Check Engine Light, we have the Toyota Certified Technicians and the certified service protocol to isolate the root problem and repair it as needed to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Toyota issue was fixed.

Every 2018 Toyota Corolla was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its critical systems. The sensors are often detecting conditions while sending data to the electronic control unit. If the electronic control unit detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what exactly is wrong nor what to do about it. That’s where we come in; Bill Estes Toyota provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Highly Qualified Service mechanical.

Is it safe to drive your 2018 Toyota Corolla with the check engine light on?

If the check engine light is blinking, this means that there is a dangerous issue and it is recommended to service your Toyota Corolla rapidly. This question is not very straightforward because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be safe to drive. This is often indicated by a acceptable glow of the check engine light. If you notice a difference in the performance of the automobile, it could be an indication of a more risky problem. Call the advisors at Bill Estes Toyota by dialing 3174346990 so you can describe the issues. Or reduce your speed and transport your 2018 Toyota to our certified mechanics as soon as feasible.

Check Engine Light Service 2018 Toyota Corolla

What do you do when you’re driving along in your Toyota Corolla and hastily, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Toyota owners, your heart sinks a tiny because you have tiny idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t mean you have to pull the automobile over to the side of the road and call a tow truck, but it is recommended that you get your 2018 Toyota Corolla checked as soon as probable. Ignoring that warning could end up causing major damage to expensive engine components.

When your 2018 Toyota Corolla's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t feasible, a computer turns on your check engine light. This amber or yellow light is customarily labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is read with an electrical scan tool that is used by our Toyota auto repair mechanics at Bill Estes Toyota. There are also a number of somewhat polite code readers that are designed for do-it-yourselfers, should you convenience that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an trained experienced to indicate the issue and repair it.

What Does the Check Engine Light Mean?

One of the most usually misunderstood lights or indicators in your 2018 Toyota Corolla is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in numerous contrasting ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light lights up in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a variety of things for your 2018 Toyota Corolla. Some of these include shifting automatic transmissions controlling engine speed, ignition timing, and implementing stability control, just to name some. With that being said, the check engine light can select a variety of innumerable things. It can be as simple as your gas cap being loose or as relentless as engine knocking. If your check engine light is on in your 2018 Toyota Corolla, contact Bill Estes Toyota. Contact Bill Estes Toyota today! Our Toyota service department can help you find out what code is turning your check engine light on or diagnose why your check engine light is flashing.

How much does it cost to get the engine light checked?

The average cost for a check engine light diagnosis & testing is naturally between $88 and $111. The superb news, Bill Estes Toyota offers complimentary multi-point inspections and free diagnostics, in most cases, to help choose the cause of your check engine light. The check engine light warns of issues ranging from a gas cap that's not properly tightened to a more compelling failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it superb to get the compelling code reading and diagnosis.

Will the check engine light reset itself?

The check engine light on your 2018 Toyota Corolla will usually shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going realistic, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2018 Toyota Corolla light will go off after about 20-40 miles. If you drive over that amount and the light is still on, you will need to bring it in to Bill Estes Toyota so the light and code can be double-checked and reset.