Please wait while the page loads...

What could cause the check engine light to come on in a 2012 Toyota 4Runner?

When your check engine light comes on, this could be as effortless as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a threatening problem that could cause threatening wear and tear to your engine and come with a extraordinary repair bill. Depending on your make and model, the check engine light will illuminate or blink. A consistent glow typically means something less threatening but a flashing check engine light expresses that your vehicle’s engine is in threatening trouble and service is essential expeditiously. If your check engine light is flashing in your 2012 Toyota 4Runner, we very recommend not to drive the vehicle and schedule Toyota service expeditiously. Below is a list of the most popular reasons your check engine light can come on:

  • The battery is meager or dead. The battery in your 2012 Toyota 4Runner is every hard. Without a vehicle battery, your vehicle won’t start, light up the road ahead, play the radio or charge your phone. Today’s vehicle batteries last much longer than they did assorted decades ago, and they don't surely require maintenance. The cost of a new one depends on the type of Toyota you drive, but check our common service coupons and specials.
  • Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, known as the O2 sensor, measures the amount of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your vehicle will be fewer feasible when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your 2012 Toyota 4Runner's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to mean the decent mixture of air and fuel that enters the cylinders in your engine. A bad O2 sensor can also cause a vehicle to fail an emissions test.
  • Your 2012 Toyota 4Runner has a vacuum leak. Every Toyota 4Runner has a vacuum system that performs a wide variety of functions. The vacuum system also helps lower combative emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dry out and crack, exceptionally if they’re exposed to intense heat or extreme brisk.
  • One of the most beneficial and copious cause is that your 2012 Toyota 4Runner gas cap is loose, damaged or missing. The gas cap for your 2012 Toyota 4Runner serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a bad fuel cap? If your gas cap is former or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't expensive. If your check engine light turns on abruptly after you put gas in your 2012 Toyota 4Runner, original thing you should check is to make convinced the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Toyota 4Runner is what determines how much fuel is essential to run your engine efficiently by measuring the amount of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to correct changes, like altitude. If your Toyota 4Runner is having trouble starting, idling rough or has a immediate change in the position of the throttle pedal, this could be a sign of a bad mass airflow sensor.
  • New Spark Plugs or Plug Wires are essential for your 2012 Toyota 4Runner. The spark plugs are the part of your engine that ignites the air/fuel mixture in the combustion chamber of your vehicle. This explosion is what moves the pistons and makes the engine run. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or former, you will experience poor performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, extensive to more expensive repairs.
  • Issues with any aftermarket items. An aftermarket alarm, exhaust or distinct item can wreak havoc on your 2012 Toyota 4Runner if it’s not installed appropriately. These aftermarket elements and accessories can deposit the battery, trigger the check engine light, or even prevent the vehicle from starting. If these issues sound beneficial, bring your 4Runner to Toyota and have our team of certified mechanics ensure that your aftermarket items were installed correctly and aren't causing any issue. Getting accessories, exceptionally aftermarket parts and accessories, or using OEM elements original place might cost a small bit more but could save you money from having to get poor work and damage caused by poor installation work corrected.
  • Your catalytic converter is bad or going bad. The catalytic converter is a part of your 2012 Toyota 4Runner’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is usually caused by neglected maintenance, which is why Bill Estes Toyota offers a complimentary multi-point inspection with every Toyota service. If you have an issue with your catalytic converter and don't get it repaired, your 2012 Toyota 4Runner will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your vehicle may run at a higher temperature, too, which can cause distinct problems from overheating.

2012 Toyota 4Runner Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that little light on your vehicle’s dashboard suddenly illuminates, but in reality, it is not something that should cause you to shut down in fear prudent away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also natural as the OBD (on-board computer diagnostic system) in your 4Runner. There are hundreds of distinguishable codes that your check engine light can determine. While that sounds daunting, with a little patience, tackling leading diagnostics will give you expanded knowledge about your vehicle and will also allow that Check Engine Light to do what it is truly supposed to do: be your guide. Regrettably, evident and cooperative vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of applicable OBD codes, there are also hundreds of applicable reasons for the light, including:

  • Loose Gas Cap or Missing Gas Cap
  • Computer output circuit issues
  • Emissions controls issues
  • Ignition system faults
  • O2 Sensor
  • Old Battery
  • Bad Spark Plugs
  • Transmission issues
  • Fuel and air metering systems problems

This is why it is necessary for someone who does not have a lot of automotive knowledge to not assume what a code means. Call Bill Estes Toyota at 3174346990 at this moment or schedule your check engine light service online today! When your check engine light comes on, you should get it checked out abruptly by a certified Toyota mechanic. If the engine light comes on due to a unhealthy concern, you risk damaging your car extra by not repairing the issue good away.

2012 Toyota 4Runner Check Engine Light Flashing

Although there are copious attainable causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are assorted favorite causes including something as commonplace as a loose gas cap. Diverse favorite reasons for a Check Engine Light are dirty mass airflow sensor, damaged oxygen sensor, faulty emissions control part, a malfunction with the fuel injection system, faulty head gasket, or defective spark plugs to name assorted. No matter what is the root cause of the Check Engine Light, we have the Toyota Certified Technicians and the certified service protocol to isolate the root problem and repair it as basic to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Toyota issue was repaired.

Every 2012 Toyota 4Runner was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its tough systems. The sensors are continually detecting conditions while sending data to the electronic control unit. If the electronic control unit detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what exactly is awry nor what to do about it. That’s where we come in; Bill Estes Toyota provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Exceedingly Qualified Service professional.

How much does it cost to get the engine light checked?

The middle cost for a check engine light diagnosis & testing is commonly between $88 and $111. The large news, Bill Estes Toyota offers complimentary multi-point inspections and free diagnostics, in most cases, to help opt for the cause of your check engine light. The check engine light warns of issues ranging from a gas cap that's not appropriately tightened to a more perilous failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it large to get the suitable code reading and diagnosis.

How many miles can you drive with the check engine light?

If you check engine light is flashing, we recommend that you pull over and contact Bill Estes Toyota to help read if your vehicle is safe to drive in or if we recommend a tow truck. It could be anything from a bad sensor to plug wires needing to be replaced. The safest bet is to decipher the code and then plan your strategy accordingly. Since each check engine code has its own level of severity, it is crucial to predict how diverse miles you can drive with the warning light on.

What Does the Check Engine Light Mean?

One of the most normally misunderstood lights or indicators in your 2012 Toyota 4Runner is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in assorted different ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a vary of things for your 2012 Toyota 4Runner. Some of these include ignition timing, shifting automatic transmissions controlling engine speed, and implementing stability control, just to name a few. With that being said, the check engine light can mean a variety of contrasting things. It can be as straightforward as your gas cap being loose or as serious as engine knocking. If your check engine light is on in your 2012 Toyota 4Runner, contact Bill Estes Toyota. Contact Bill Estes Toyota today! Our Toyota service department can help you find out what code is turning your check engine light on or diagnose why your check engine light is flashing.

Will the check engine light reset itself?

The check engine light on your 2012 Toyota 4Runner will usually shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going decent, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2012 Toyota 4Runner light will go off after about 20-40 miles. If you drive over that sum and the light is still on, you will need to bring it in to Bill Estes Toyota so the light and code can be double-checked and reset.

Is it safe to drive your 2012 Toyota 4Runner with the check engine light on?

If the check engine light is flashing, this means that there is a relentless issue and it is recommended to service your Toyota 4Runner swiftly. This question is not exceedingly pure because it any depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be safe to drive. This is frequently indicated by a consistent glow of the check engine light. If you notice a difference in the performance of the car, it could be an indication of a more relentless problem. Call the mentors at Bill Estes Toyota by dialing 3174346990 so you can describe the issues. Or lower your speed and deliver your 2012 Toyota to our certified mechanics as soon as probable.

Check Engine Light Service 2012 Toyota 4Runner

What do you do when you’re driving along in your Toyota 4Runner and suddenly, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Toyota owners, your heart sinks a little because you have little idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t mean you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your 2012 Toyota 4Runner checked as soon as feasible. Ignoring that warning could end up causing major damage to expensive engine parts.

When your 2012 Toyota 4Runner's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t correct, a computer turns on your check engine light. This amber or yellow light is customarily labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is opt for with an electronic scan tool that is used by our Toyota auto repair mechanics at Bill Estes Toyota. There are also a number of relatively small code readers that are designed for do-it-yourselfers, should you designate that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an experienced professional to indicate the issue and repair it.

2012 Toyota 4Runner Check Engine Light

A flashing light indicates that the problem is remarkable and if not taken care of immediately may result in major break to the vehicle. If the check engine light in your 2012 Toyota 4Runner starts flashing, that means that the problem needs urgent attention and your Toyota should be transported in immediately. This blinking light usually indicates a severe engine misfire allowing unburned fuel to be ditched into the exhaust system. There it can promptly boost the temperature of the catalytic converter to a point where damage is conceivable, requiring an lavish repair. Some owners ask if spark plugs cause the check engine light to flash? This can genuinely be the cause. A bad, classic or dirty spark plug can cause the engine to misfire. If the problem is ignored or you continue to commute, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a very expensive repair. If your check engine light is flashing, please contact our team of automotive experts at Bill Estes Toyota abruptly by calling 3174346990.